What are the troubleshooting methods for curing machines?

Spindle wear
As the vulcanizing machine for metal materials, high hardness, in the production process of vibration and other complex forces, resulting in the formation of parts of the gap, resulting in wear. The traditional methods are welding, thermal spraying, brush plating, but several methods have some drawbacks: welding makes the part surface reach very high temperature, causing parts deformation or cracks, affect the dimensional accuracy and normal use, can lead to serious fracture; no heat affected brush Du, but not too cross layer thickness thick, serious pollution, the application has been greatly limited. Western countries for the above problems using polymer composite materials. The utility model has the advantages of comprehensive performance and mechanical processing at any time, which can meet the requirements of the repair and the precision, and can reduce the impact vibration and prolong the service life of the equipment in operation. Because the material is a "variable" relationship, when the external impact of the material, the material will deform to absorb the external force, and with the expansion of the bearing or other parts of the expansion and contraction, and always maintain a tight fit with the components, reducing the probability of wear. To wear large vulcanizing machine, can be used "die" or "mating parts for damaged equipment for on-site repair, avoid the whole demolition equipment, to ensure maximum parts size, meet the production requirements for equipment operation.
Weld leakage
Vulcanizing machine in the long run, because of vibration, abrasion, temperature and pressure, repeated disassembly and so on, all of the static seal leakage phenomenon is very common, there is a common vulcanizing machine hot plate welding seam leakage etc.. Not only a large number of waste oil, but also affect the site management. Traditional methods to remove and open the vulcanizing machine, replace the sealing gasket or apply sealant, not only time-consuming, but it is difficult to ensure the sealing effect, the operation will leak again. The United States for technology field governance leakage, without disassembly. It has excellent adhesion, oil resistance and tensile strength of 350%, not only can stop plugging and sealing, but also in the premise of not affecting the production of online standby leakage management, achieve the purpose of re sealing, significant economic benefits.
Floor corrosion
The bottom of the vulcanizing machine is made of ordinary carbon steel, and the tire is vulcanized by high temperature steam. In this process, some of the water is condensed to the surface of the base plate. Due to the serious corrosion of the surface of the base plate, and the surface of the heat insulation plate can not be closely coordinated, it is very easy to cause the damage of the insulation board under the large pressure. The traditional method of re surfacing after welding or replacement of new equipment based on the current can be used to carry out on-site repair of polymer composites. Because the material has excellent adhesion, good corrosion resistance, good compressive strength, can solve the effective plate vulcanizing machine in the operation process of water condensation caused by uneven corrosion of bottom plate, so as to avoid insulation failure, for the normal operation of the user equipment, production safety and provided good protection.