Do you know the working principle of mixer?

The mixer is a rotor, a specific shape and has a relative rotation in the closed state of adjustable temperature and pressure of clearance of the polymer material plastication and mixing machine, mainly by the mixing chamber, a rotor, a rotor sealing device, feeding pressure device, unloading device, transmission and chassis components.
Mixer work, two rotor relative rotation, the material from the feed inlet will be clamped into the gap by extrusion and shearing of the rotor through the roll gap after hit top to sharp edge is divided into two parts, respectively along the wall and go back to the room before and after the rotor gap between the roll gap above. In a week around the rotor flow, shear and friction materials are everywhere, the compound rapid temperature rise, reduced viscosity increased with the wetting agent in the rubber surface, the rubber and compound full contact surface. The complexing agent is connected with the rubber material through the gap between the rotor and the rotor, the rotor is connected with the upper and the lower crown, and the inner wall of the interior wall is sheared and broken. At the same time, the convex edge of the rotor causes the rubber material to move along the axial direction of the rotor, so as to stir and mix. The complexing agent is repeatedly broken, the rubber material repeatedly generates deformation and the deformation is restored, and the continuous stirring of the convex ribs of the rotor makes the complexing agent evenly dispersed in the rubber material and reaches a certain degree of dispersion. Due to the mixing of the mixer when the shear effect of the rubber material is much larger than the opening machine, high temperature, so that the efficiency of mixing machine is much higher than the mixer.
Mixer work, two rotor relative rotation, the material from the feed inlet will be clamped into the gap by extrusion and shearing of the rotor through the roll gap after hit top to sharp edge is divided into two parts, respectively along the wall and go back to the room before and after the rotor gap between the roll gap above. In a week around the rotor flow, shear and friction materials are everywhere, the compound rapid temperature rise, reduced viscosity increased with the wetting agent in the rubber surface, the rubber and compound full contact surface. The complexing agent is connected with the rubber material through the gap between the rotor and the rotor, the rotor is connected with the upper and the lower crown, and the inner wall of the interior wall is sheared and broken. At the same time, the convex edge of the rotor causes the rubber material to move along the axial direction of the rotor, so as to stir and mix. The complexing agent is repeatedly broken, the rubber material repeatedly generates deformation and the deformation is restored, and the continuous stirring of the convex ribs of the rotor makes the complexing agent evenly dispersed in the rubber material and reaches a certain degree of dispersion. Due to the mixing of the mixer when the shear effect of the rubber material is much larger than the opening machine, high temperature, so that the efficiency of mixing machine is much higher than the mixer.