Introduction to the eight point performance of small vulcanizer

1, PLC, HMI control, manual and automatic control can be achieved. Automatic control can be achieved mold, exhaust, temperature control, curing time, alarm, mold unloading, and other functions.
2, the hydraulic cylinder using ZG270-500 material, the plunger adopts the texture of chilled alloy cast iron, after casting fine grinding; hydraulic cylinder sealing form for YX sealing ring.
3, the hot plate side of the pot with hydraulic automatic iron, in the role of the four hot plate on both sides of the pad iron at the same time back and forth.
4, each heating zone of the hot plate is provided with a set of temperature regulating valve groups, under the control of the PLC, the temperature of each heating zone of the hot plate is uniform.
5, hydraulic system: the use of domestic and foreign well-known brands of hydraulic station, under the control of PLC, can achieve automatic: mold, exhaust, open mold unloading.
6, mechanical synchronous balancing mechanism: in the bottom of the platform there is always wear the synchronous shaft unit, both ends of the shaft with gear rack, to ensure the level of the platform.
7, the mold guide device: on both sides of the lower pad is equipped with a mold guide device, the frame plate and the platform to install the guide seat, the guide seat processing inclined plane, can be adjusted through the top of the slant distance.
8, open mold power mechanism: when the mold is located in the platform under the four oil cylinder action, the platform forced to pull down, to prevent sticking pot open mold phenomenon.