How to solve the current instability of the small extruder?

How to solve the current instability of the small extruder?

Mechanical equipment in daily use, as time goes by some small faults in the common sense, a small extruder in the daily operation of the host, the current instability has become one of the common faults, for the following reasons for the failure of all the detail in and troubleshooting:

1, plastic extruder main current instability reasons:

(1) uneven feeding.

(2) damage of main motor bearing or bad lubrication.

(3) a heater is out of order and not heated.

(4) the screw adjustment pad is wrong, or the phase is wrong, and the component interferes.

2, plastic extruder host current instability:

(1) inspect the feeder and troubleshoot.

(2) overhaul the main motor and replace the bearings if necessary.

(3) check whether the heaters work properly and replace the heater when necessary.

(4) check the adjusting pad, pull out the screw and check whether the screw is interference.

(data comes from the Internet for reference only