What preparations should be made before the operation of a small mixer?

What preparations should be made before the operation of a small mixer?

First, the preparatory work:

1. Prepare raw rubber, oil, small materials according to the needs of the products;

2, check pneumatic FRL within the cup if there is oil, no oil fill. Check the oil content of the reducer, the amount of air compressed oil is not less than 1/3 of the center oil level, start the air compressor, the air compressor will automatically stop after reaching 8Mpa, and release the moisture in the pneumatic triplex;

3, to the chamber door handle, open the chamber door, ready to press the button, switch on the power, small panel power indicator light, the top bolt knob to "up" the position of the top bolt in place after the rise, the mixing chamber knob to the mixing chamber to "turn" the position of the mixing chamber, will automatically stop and turn out, during the mixing chamber changes the sound and light alarm alarm, carefully check the mixing chamber shall not be more than expected, the impurity, mixing chamber to "knob rotation position", the mixing chamber to the back flip and automatically stop, mixing the middle position of the mixing chamber of the knob a temperature alarm according to different kinds of rubber mixing set required.